Alpha Hot Water – Error Code 2

Alpha Hot Water System – Error Code 2

Is your Alpha hot water system showing up with Error Code 2 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 2 and whether you should keep using your Alpha hot water system.

What is a Alpha Error Code 2?

The Alpha Hot Water System has an Error Code 2, which means that: Alpha Water Heater Error Code 2 is a problem that occurs when the boiler gets too hot and shuts down to prevent any damage. This error code usually indicates a problem with the pump or the flow of water in the system. It could be caused by a blocked heat exchanger, which is a part that helps transfer heat from the water to the surrounding area. Another possible cause is air trapped in the system, which can disrupt the flow of water. When this error code appears, it is important to check for any blockages in the heat exchanger and ensure that there is no air in the system.

Recommended solution/fix steps

To fix Alpha Water Heater Error Code 2, follow these steps. First, turn off the water heater and let it cool down completely. Next, check for any blockages in the heat exchanger by inspecting the pipes and connections. If you find any debris or buildup, clean it out carefully. Then, check the water flow by ensuring that the pump is working correctly. If the pump is faulty, you may need to replace it. Additionally, check for any air trapped in the system by bleeding the radiators or using the air vent valve. Finally, restart the water heater and monitor it for any further issues. If the error persists, it is recommended to contact a professional plumber for assistance

How to reset my Alpha Hot Water System

To reset the Alpha Water Heater with Error Code 2, follow these steps:

1. Turn off the power supply to the water heater by switching off the circuit breaker or unplugging it.
2. Locate the reset button on the water heater. It is usually a small red or black button.
3. Press and hold the reset button for about 10 seconds.
4. While still holding the reset button, turn on the power supply to the water heater.
5. Continue holding the reset button for another 10 seconds.
6. Release the reset button and wait for a few minutes to allow the water heater to reset.
7. After the waiting period, check if the error code has cleared. If it has, the water heater should be functioning normally again.
8. If the error code persists, it is recommended to contact a professional technician for further assistance

Can I still use my Alpha hot water system?

The Alpha Water Heater with Error Code 2, indicating an overheat boiler lockout, cannot be used until the issue is resolved. This fault code suggests a pump or flow problem, which could be caused by a blocked heat exchanger or air in the system. It is important to address this issue promptly to prevent further damage to the appliance and ensure its safe operation. Professional assistance may be required to diagnose and fix the problem, allowing the water heater to be used again once the fault code is resolved