About the Alpha Hot Water Error Code 47: Reduced burner output, which could be due to high flue gas temperature or restricted primary flow.
Alpha Hot Water – Error Code 47
📚 Contents
Alpha Hot Water System – Error Code 47
Is your Alpha hot water system showing up with Error Code 47 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 47 and whether you should keep using your Alpha hot water system.
What is a Alpha Error Code 47?
The Alpha Hot Water System has an Error Code 47, which means that: Error Code 47 on the Alpha Water Heater means that the burner is not producing enough heat. This could happen because the temperature of the gas in the flue is too high or because the primary flow of water is restricted.
When the flue gas temperature is too high, it can cause the burner to work less efficiently and produce less heat. This could be due to a problem with the ventilation system or a blockage in the flue. On the other hand, if the primary flow of water is restricted, it means that there is not enough water flowing through the heater to properly heat it. This could be caused by a clogged filter or a problem with the water supply. In either case, it is important to address the issue to ensure that the water heater functions properly and provides hot water efficiently.
Recommended solution/fix steps
To fix Alpha Water Heater Error Code 47, follow these steps:
1. Check the flue gas temperature: Ensure it is not too high. If it is, the heater may need to be serviced or cleaned to improve the burner output.
2. Inspect the primary flow: Make sure there are no restrictions or blockages in the water flow. Clean or remove any debris or buildup that may be causing the reduced burner output.
3. Reset the water heater: Turn off the power supply to the heater, wait for a few minutes, and then turn it back on. This can sometimes resolve temporary issues.
4. Contact a professional: If the error persists after performing the above steps, it is recommended to call a qualified technician or the manufacturer’s customer service for further assistance and potential repairs
How to reset my Alpha Hot Water System
To reset the Alpha Water Heater with Error Code 47, follow these steps:
1. Turn off the power supply to the water heater by switching off the circuit breaker or unplugging it.
2. Locate the reset button on the water heater. It is usually a small red or black button.
3. Press and hold the reset button for about 10 seconds.
4. Release the reset button and wait for a few minutes.
5. Turn on the power supply to the water heater by switching on the circuit breaker or plugging it back in.
6. Wait for the water heater to restart and check if the Error Code 47 is cleared.
7. If the error persists, it is recommended to contact a professional technician for further assistance
Can I still use my Alpha hot water system?
The Alpha Water Heater with Error Code 47 indicates a reduced burner output, possibly caused by a high flue gas temperature or restricted primary flow. In this case, the appliance may still be used, but caution is advised. It is important to address the underlying issue causing the fault code to ensure proper functioning and prevent further damage. A high flue gas temperature could indicate a problem with the ventilation system, while a restricted primary flow may require cleaning or maintenance of the water heater. It is recommended to consult the manufacturer’s manual or contact a professional technician for assistance in resolving the fault code and ensuring the safe and efficient operation of the appliance
