Keeprite Error Code 6 + 1: The Keeprite Furnace has an error code called 6 + 1, which means ignition lockout. This error occurs when the furnace fails to ignite properly. When this happens, the control system of the furnace will automatically shut down and lockout the ignition process. This is done to prevent any potential hazards or damage to the furnace. The control system will then try to reset itself after a period of 3 hours. During this time, it is important to not attempt to manually reset the furnace or tamper with any components. It is recommended to wait for the auto-reset process to complete before trying to use the furnace again.
Keeprite Furnace – Error Code 6 + 1
📚 Contents
Keeprite Furnace – Error Code 6 + 1
Is your Keeprite furnace showing up with Error Code 6 + 1 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 6 + 1 and whether you should keep using your Keeprite furnace.
What is a Keeprite Error Code 6 + 1?
The Keeprite Furnace has an error code called 6 + 1, which means ignition lockout. This error occurs when the furnace fails to ignite properly. When this happens, the control system of the furnace will automatically shut down and lockout the ignition process. This is done to prevent any potential hazards or damage to the furnace. The control system will then try to reset itself after a period of 3 hours. During this time, it is important to not attempt to manually reset the furnace or tamper with any components. It is recommended to wait for the auto-reset process to complete before trying to use the furnace again.
Recommended solution/fix steps
If you see Error Code 6 + 1 on your Keeprite Furnace, it means there is an ignition lockout. The control will automatically reset after 3 hours. To resolve this issue, you can try the following steps:
1. Turn off the power to the furnace by switching off the circuit breaker or disconnecting it from the power source.
2. Wait for at least 10 minutes to allow the furnace to cool down.
3. Check the air intake and exhaust pipes for any blockages or obstructions. Clear them if necessary.
4. Inspect the ignition system for any loose connections or damaged components. Tighten or replace as needed.
5. Ensure that the gas supply to the furnace is turned on and the gas valve is fully open.
6. After the 3-hour auto-reset period, turn the power back on and observe if the error code reappears.
If the error code persists or you are unsure about performing these steps, it is recommended to contact a.
Fault codes that are often associated with or mistaken for error code 6 + 1 are: 61, 62, 65, 68, 6B, 6i, 6Z, 6S, 6B, 6b
Can I still use my Keeprite furnace?
After seeing Error Code 6 + 1 on the Keeprite Furnace, the machine can still be operated. This error code indicates an ignition lockout, which means that the control system has detected a problem with the ignition process. However, the control will automatically reset itself after three hours. This means that the furnace will be able to resume normal operation once the reset occurs. It is important to note that during this three-hour period, the furnace will not be able to ignite and provide heat. Therefore, it is advisable to monitor the furnace closely and ensure that it resets properly to avoid any further issues.
