Phocos – Error Code 10

Phocos Solar Inverter – Error Code 10

Is your Phocos solar inverter showing up with Error Code 10 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 10 and whether you should keep using your Phocos solar inverter.

What is a Phocos Error Code 10?

The Phocos Solar Inverter has an Error Code 10, which means that: Error Code 10 on the Phocos Solar Inverter indicates that there is an over-current issue with the solar charge controller. This means that the amount of current flowing through the charge controller is higher than what it is designed to handle. This can happen due to various reasons such as a faulty component, a short circuit, or an overload in the system.

When this error occurs, it is important to check the wiring and connections of the solar charge controller to ensure they are secure and not damaged. It is also recommended to inspect the solar panels and other components for any signs of damage or malfunction. If the issue persists, it is advisable to contact a professional technician or the manufacturer for further assistance in resolving the over-current problem and getting the solar inverter back to normal operation.

Recommended solution/fix steps

To fix Phocos Solar Inverter Error Code 10, follow these steps:

1. Turn off the solar inverter and disconnect it from the power source.
2. Check the solar charge controller for any visible damage or loose connections.
3. If there are any loose connections, tighten them securely.
4. Inspect the solar panels and wiring for any signs of damage or wear.
5. If any damage is found, repair or replace the affected components.
6. Allow the solar charge controller to cool down for a few minutes.
7. After cooling, reconnect the solar inverter to the power source.
8. Turn on the solar inverter and monitor it for any recurring error codes.
9. If the error code persists, contact a professional technician or the manufacturer for further assistance

How to reset my Phocos Solar Inverter

To reset the Phocos Solar Inverter with Error Code 10 (indicating a solar charge controller over-current), follow these steps:

1. Turn off the solar inverter by switching off the main power supply.
2. Disconnect the solar panels from the inverter.
3. Wait for about 5 minutes to allow the system to fully discharge.
4. Reconnect the solar panels to the inverter.
5. Turn on the main power supply to restart the inverter.
6. Check if the error code has cleared. If it persists, contact a professional technician for further assistance.

Remember to exercise caution while working with electrical equipment and consult the user manual or manufacturer’s guidelines for specific instructions related to your Phocos Solar Inverter model

Can I still use my Phocos solar inverter?

After seeing error code 10 on the Phocos Solar Inverter, which indicates an over-current issue with the solar charge controller, it is not recommended to continue using the appliance. This fault code suggests that there is excessive current flowing through the charge controller, which can potentially damage the inverter or other components of the system. It is important to address this issue promptly to prevent further damage and ensure the safe operation of the appliance. Consulting the manufacturer’s manual or contacting a professional technician for assistance is advised to resolve the over-current problem and restore the functionality of the solar inverter