Utica Boiler – Error Code 6

Utica Boiler – Error Code 6

Is your Utica boiler showing up with Error Code 6 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 6 and whether you should keep using your Utica boiler.

What is a Utica Error Code 6?

The Utica Boiler has an Error Code 6, which means that: Utica Boiler Error Code 6 means that the flame in the boiler is not behaving as it should. Normally, the flame should ignite and burn in a specific order, but in this case, it is not following that order. This can be a problem because it may cause the boiler to not work properly or even shut down completely. It is important to address this error code as soon as possible to ensure that the boiler is functioning safely and efficiently. A professional technician should be called to diagnose and fix the issue, as they will have the knowledge and expertise to determine the cause of the problem and make the necessary repairs.

Recommended solution/fix steps

To fix Utica Boiler Error Code 6, follow these steps:

1. Turn off the boiler and wait for it to cool down.
2. Check the flame sensor for any dirt or debris. Clean it gently using a soft cloth.
3. Inspect the wiring connections between the flame sensor and the control board. Ensure they are secure and not damaged.
4. Reset the boiler by turning off the power supply for a few minutes, then turning it back on.
5. Restart the boiler and observe if the error code persists.
6. If the error code continues, it may indicate a faulty flame sensor or control board. In this case, it is recommended to contact a professional technician for further assistance

How to reset my Utica Boiler

To reset the Utica Boiler with Error Code 6, follow these steps:

1. Locate the power switch or circuit breaker for the boiler and turn it off.
2. Wait for about 30 seconds to allow the boiler to fully shut down.
3. After the waiting period, turn the power switch or circuit breaker back on.
4. The boiler will start its ignition sequence and attempt to relight the flame.
5. If the flame is successfully relit, the boiler will resume normal operation.
6. However, if the error code persists or the flame fails to relight, it may indicate a more serious issue.
7. In such cases, it is recommended to contact a professional technician or the manufacturer for further assistance

Can I still use my Utica boiler?

After seeing the fault code “Utica Boiler Error Code 6: Flame sensed out of normal sequence,” it is recommended to not use the appliance until the issue is resolved. This fault code indicates that the flame is not operating in the expected sequence, which could potentially lead to unsafe conditions or further damage to the appliance. It is important to contact a professional technician or the manufacturer to diagnose and fix the issue before using the appliance again. Ignoring this fault code and continuing to use the appliance may pose a risk to safety and could result in further damage or malfunction