Voltronic Power – Error Code 6

Voltronic Power Solar Inverter – Error Code 6

Is your Voltronic Power solar inverter showing up with Error Code 6 on the screen? In this article, we’ll look at why it is happening, some potential next steps for fixing error code 6 and whether you should keep using your Voltronic Power solar inverter.

What is a Voltronic Power Error Code 6?

The Voltronic Power Solar Inverter has an Error Code 6, which means that: The Voltronic Power Solar Inverter Error Code 6 means that there is a problem with the output voltage of the inverter. This error code is specific to different models of the inverter. For the 1K, 2K, and 3K models, the output voltage is abnormal, which means it is not at the right level. For the 4K and 5K models, the output voltage is too high, which means it is higher than it should be. This error code can be caused by a variety of issues, such as a malfunctioning component or a problem with the wiring. If you see this error code on your inverter, it is important to get it fixed as soon as possible to avoid any damage to your solar system.

Recommended solution/fix steps

To fix the Voltronic Power Solar Inverter Error Code 6, follow these steps:

1. Check the output voltage using a multimeter to confirm if it is indeed abnormal or too high.
2. If the voltage is abnormal, ensure that the inverter is properly connected to the solar panels and the grid.
3. Inspect the wiring for any loose connections or damage, and tighten or replace as necessary.
4. If the voltage is too high, check if the inverter is set to the correct output voltage for your specific model (1K/2K/3K or 4K/5K).
5. Adjust the output voltage settings on the inverter to the recommended levels.
6. If the issue persists, consult the user manual or contact the manufacturer’s customer support for further assistance

How to reset my Voltronic Power Solar Inverter

To reset the Voltronic Power Solar Inverter and fix Error Code 6, follow these steps:

1. Turn off the inverter by pressing the power button or disconnecting it from the power source.
2. Wait for at least 5 minutes to allow the inverter to fully power down.
3. Locate the reset button on the inverter. It is usually a small button labeled “Reset” or “RST.”
4. Press and hold the reset button for about 10 seconds.
5. Release the reset button and wait for a few seconds.
6. Turn on the inverter by pressing the power button or reconnecting it to the power source.
7. Check if the error code has cleared and the output voltage is back to normal.

If the error persists after following these steps, it is recommended to contact a professional technician for further assistance

Can I still use my Voltronic Power solar inverter?

If the appliance is a Voltronic Power Solar Inverter with Error Code 6, it cannot be used until the fault is resolved. Error Code 6 indicates that the output voltage is abnormal or too high, depending on the model. This fault can potentially damage connected devices or pose a safety risk. It is important to address the issue promptly by contacting a professional technician or the manufacturer for assistance. Continuing to use the appliance in this state may result in further damage or malfunction